ZyXEL Communications ZyAIR B-420 User Manual page 86

ZyAIR B-420 Wireless LAN Ethernet Adapter and Bridge
FIELD
Select Disable to allow wireless stations to communicate with the access
WEP
points without any data encryption.
Encryption
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Enter the key number (1 to 4) in this field. Only one key can be enabled at
Default Key any one time. This key must be the same on the ZyAIR and the wireless
stations to communicate.
The WEP keys are used to encrypt data. Both the ZyAIR and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5
ASCII characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 ASCII
Key 1 to Key 4
characters or 26 hexadecimal characters ("0-9", "A-F").
Authen. Press [SPACE BAR] to select Auto, Open System Only or Shared Key
Method Only and press [ENTER].
This field is N/A if WEP is not activated.
If WEP encryption is activated, the default setting is Auto.
Breathing LED Press [SPACE BAR] to select Yes or No and press [ENTER].
Press [SPACE BAR] to select 11dBm, 13dBm, 15dBm or 17dBm and press
Output Power
[ENTER].
This field is only available when you select Bridge in the Operating Mode
Edit Bridge
field.
Link
Configuration
Press [SPACE BAR] to select Yes or No and press [ENTER].
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
10-4
Table 10-2 Menu 3.5 Wireless LAN Setup
Enter "0x" before the key to denote a hexadecimal key.
Don't enter "0x" before the key to denote an ASCII key.
DESCRIPTION EXMAPLE
Disable
1
0x12345ab
cde
Auto
17dBm
N/A
LAN Setup