Console Port Speed; Figure 12-5 Menu 24.2.2 System Maintenance : Change Console Port Speed; Table 12-2 System Maintenance : Information - ZyXEL Communications ZyAIR B-420 User Manual

ZyAIR B-420 Wireless LAN Ethernet Adapter and Bridge
The following table describes the fields in this menu.
FIELD
Name
Routing
ZyNOS F/W
Version
Country Code
LAN
Ethernet Address
IP Address
IP Mask
DHCP
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

12.2.2 Console Port Speed

You can set up different port speeds for the console port through Menu 24.2.2 – System Maintenance –
Console Port Speed. Your ZyAIR supports 9600 (default), 19200, 38400, 57600 and 115200 bps console
port speeds. Press [SPACE BAR] and then [ENTER] to select the desired speed in menu 24.2.2, as shown
in the following figure.

Figure 12-5 Menu 24.2.2 System Maintenance : Change Console Port Speed

After you changed the console port speed on your ZyAIR, you must also make the same change to the
console port speed parameter of your communication software.
12-4

Table 12-2 System Maintenance : Information

Displays the system name of your ZyAIR. This information can be changed in
Menu 1 – General Setup.
Refers to the routing protocol used.
Refers to the ZyNOS (ZyXEL Network Operating System) system firmware version.
ZyNOS is a registered trademark of ZyXEL Communications Corporation.
Refers to the country code of the firmware.
Refers to the Ethernet MAC (Media Access Control) of your ZyAIR.
This is the IP address of the ZyAIR in dotted decimal notation.
This shows the subnet mask of the ZyAIR.
This field shows the DHCP setting of the ZyAIR.
Menu 24.2.2 – System Maintenance – Change Console Port Speed
Console Port Speed: 9600
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
System Information