Chapter 8 Introducing The Smt; Connect To Your Zyair Using Telnet; Changing The System Password; Figure 8-1 Login Screen - ZyXEL Communications ZyAIR B-420 User Manual

This chapter describes how to access the SMT and provides an overview of its menus
8.1

Connect to your ZyAIR Using Telnet

The following procedure details how to telnet into your ZyAIR.
Step 1. In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.11" (the default IP address) and click OK.
Step 2.
For your first login, enter the default password "1234". As you type the password, the screen
displays an "x" for each character you type.
Step 3. After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after you log in,
your ZyAIR will automatically log you out. You will then have to telnet into the ZyAIR again. You can use
the web configurator or the CI commands to change the inactivity time out period.
8.2

Changing the System Password

Change the ZyAIR default password by following the steps shown next.
Step 1. From the main menu, enter 23 to display Menu 23 – System Security.
Step 2. Enter 1 to display Menu 23.1 – System Security – Change Password as shown next.
Step 3. Type your existing system password in the Old Password field, and press [ENTER].
Introducing the SMT
Password : xxxx

Figure 8-1 Login Screen

ZyAIR B-420 Wireless LAN Ethernet Adapter and Bridge
Introducing the SMT
Chapter 8
8-1
.