Safety Signs - Exmark Ultra Vac Frontrunner Operator's Manual

•
The operating characteristics of the machine will change with the Ultra Vac
installed. The stability and traction of the machine will change as the Ultra
Vac hopper fills with grass clippings. Use progressively greater care on
slopes as the hopper fills.
•
Always install and remove the Ultra Vac as instructed. Failure to do so will
cause a reduction in stability or traction. Do not operate the mower with only
a portion of the Ultra Vac installed.

1.5 SAFETY SIGNS

1.5.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety signs
and instructional labels.
1.5.2 Safety signs must be replaced if they are missing or illegible.
1.5.3 When new components are installed, be sure that current safety signs are affixed
to the replaced components.
1.5.4 New safety signs may be obtained from your authorized Exmark equipment
dealer or distributor or from Exmark Mfg. Co. Inc.
1.5.5 Safety signs may be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.5.6 Familiarize yourself with the following safety signs and instruction labels. They are
critical to the safe operation of your Exmark Ultra Vac.
PART NO. 109-5890
LOCATION: Top of Blower
PART NO. 1-513746
LOCATION: On Muffler Shield
for Briggs and
Stratton Engine
PART NO. 98-5954
LOCATION: Under Blower Cover
5
PART NO. 109-5606
LOCATION: Front Left ROPS
PART NO. 103-8444
LOCATION: Lower Door Links