Safety Signs; Specifications; Model Number - Exmark Ultra Vac Operator's & Parts Manual

1.3.2 While mowing, always wear substantial footwear and long trousers. Do not operate
equipment when barefoot or when wearing open sandals.
1.3.3 Thoroughly inspect the area where the equipment is to be used and remove all
stones, sticks, wires, bones and other foreign objects which may cause personal injury
to the operator or bystanders or damage the equipment.

1.4 SAFETY SIGNS

1.4.1 Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and
instructional labels.
1.4.2 Safety signs must be replaced if they are missing or illegible.
1.4.3 When new components are installed, be sure that current safety signs are affixed to
the replaced components.
1.4.4 New safety signs may be obtained from your authorized Exmark equipment dealer or
distributor or from Exmark Mfg. Co. Inc.
1.4.5 Safety signs may be affixed by peeling off the backing to expose the adhesive
surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.
1.4.6 Familiarize yourself with the following safety signs and instruction labels. They are
critical to the safe operation of your Exmark commercial mower.
PART NO. 1-653554
LOCATION: Rear of Bags

2. SPECIFICATIONS

2.1 MODEL NUMBER:

LHPUV4448
Use with drive kit:
Note: Lazer HP model LHP4818KC Serial Nos. below 176621 will also require adapter kit 103-0328
LHPUV52
Use with drive kit:
PART NO. 103-0220
LOCATION: Top of Blower
44" deck – 1-651361
48" deck – 1-651359 (Lazer HP Serial Nos. below 203,376)
48" deck – 1-651360 (Lazer HP Serial Nos. 203,376 & higher)
52" deck – 1-651360
7
PART NO. 1-653556
LOCATION: Side of Blower Housing (2 Places)
PART NO. 1-653558
LOCATION: Top of Idler Arm