Exmark Ultra Vac Frontrunner Operator's Manual page 14

POTENTIAL HAZARD
♦ An uncovered discharge opening will
allow objects to be thrown in an
operator's or bystander's direction. Also,
contact with the blade could occur.
WHAT CAN HAPPEN
♦ Thrown objects or blade contact can
cause serious injury or death.
HOW TO AVOID THE HAZARD
♦ Never operate the mower with the
discharge deflector raised, removed, or
altered unless there is a grass collection
system or mulch kit in place and working
properly.
3.3.7 Re-install the plastic belt cover and tighten the knobs.
3.3.8 Unplug the wiring for the fill sensor at the front of the hopper. Secure loose wire
harness by routing loose end partially back down ROPS tube.
3.3.9 Remove the hair pins and clevis pins holding the hopper assembly to the ROPS
weldment.
3.3.10 Rotate the hopper assembly rearward until the back of the door rests on the
ground. Remove the hair pins holding the lower hopper links to the lower frame
mount (see Figure 4).
3.3.11 The bracket bolted to the rear of the frame at the ROPS remains on the unit.
Note: The portions of the FrontRunner Ultra Vac bagger that are not bolted to the
mower are designed to be installed or removed in their entirety. Failure to
do so will cause a reduction in stability or traction. Do not operate the
mower with only a portion of the FrontRunner Ultra Vac installed.
3.3.12 The machine can now be used for side discharge mowing.
FIGURE 3
DANGER
9