Advertisement
The batteries can also be taken from the containers
and charged somewhere else, indoors for instance.
To do this:
1. Loosen the charge connector of the batteries
from the charging point under the seat.
2. Undo the lock of the fastening device and open
it.
3. Take the batteries from the containers.
4. Put the batteries down and connect the charge
connector of the batteries to the connector of
the charger.
5. Put the charger plug in the wall socket. The red
light will light up.
6. Depending on the state of the battery it will take
4 to 12 hours to fully charge.
7. As soon as the battery is charged, first take the
plug from the wall socket.
8. Then take the charge connector of the batteries
from the connector of the charger.
9. Place the batteries back in the containers on the
bicycle and lock the fastening devices.
10. Then, connect the charge connector of the
batteries to the connector of the charging point
again.
Beware:
Charge the battery until the green lamp lights up.
Never interrupt the charging process.
For the lifespan of the battery it is better to charge
the battery when it is almost discharged.
It is damaging for the battery if it is not used for
more than 2 months. In that case charge the battery
every now and then.
The case of the charger may not be opened by the
buyer. In the event of problems go to your dealer!
Only use the charger in non-humid indoor spaces.
Below 5 degrees Celsius the charger will not
function properly. In that case it is advisable to
charge the batteries indoors.
Extra accessories are available at your dealer.
User manual
Fun-2-Go 06.13
1.
3.
5.
2.
4.
20
Advertisement
