Navigation Setup - Kenwood DNX7140 Instruction Manual

Navigation Setup
You can set Navigation parameters.
D
Display the Navigation Setup screen
Touch
[ttl> [,..,
1
>
[Navigation]. (page 63)
II
Set each item
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system.
([2)
"Front All")
"Front
L":
Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
(f2]
DNX models: "25", DDX models: "21 ")
[Line Mute] Mutes the volume during voice
guidance of the navigation system.
([2]
"ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input] Selects a navigation
system connection.
([2]
"RGB") (DDX models
only)
"RGB": Allows the Kenwood's Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to
connect via the AV INPUT1 port
"OFF": Must be used
if
no navigation system
is connected. (The navigation display
is cancelled when the AV source is
sWitched.)
[On Screen Navigation] Sets an on-screen
display of the navigation screen.
((~J
"OFF")
(DDX models only)
"Auto": Information is displayed for 5 seconds
when updated.
"OFF": Information is not displayed.
English 77