Monitor Angle Control; Ext Sw Setup - Kenwood DNX7140 Instruction Manual

Monitor Angle Control
You can adjust the position of the monitor.
D
Display the Angle Setup screen
Touch [et]
>
[~]
>
[System]
>
[Angle]
(page 63)
II
Set the Monitor Angle
[I]
Sets the Monitor angle.
[Memory] Stores the current monitor angle as
~
the angle during power off.
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from this
unit.
D
Display the Angle Setup screen
Touch [0]
>
[~]
>
[System]
>
[EXT SW]
(page 63)
,II
Perform EXT SW Setup
[SW Name] Sets the name of the external
device. See <Character Entry> (page 47) for
information on how to enter the name.
[Output Pattern] Sets the power signal output
mode.
d21
EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
~
"Level": Continues output of high power signal.
.-J
Sets to turn output on/off each time
the button on the EXT SW Control
screen is touched.
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when" 1" is set. Increases by
200ms with each step. Up to 100 steps can
be set.
English 69