Av Interface Setup; Navigation Setup; [Navigation]; [Av Interface] - Kenwood DDX630BT Instruction Manual

AV Interface Setup

You can set audio and visual (AV) interface
parameters.
1 Display the AV Interface screen
>
Touch [ ] [
2 Set each item
[AV-OUT] Selects an AV source to be output at
the AV OUTPUT port. (
[R-CAM Interrupt] Sets a method to switch to
the rear view camera video display.
( "OFF")
"ON": Switches to the rear camera video
display when "Reverse" gear is engaged.
"OFF": The monitor does not switch to the
rear view camera video display even
when engaging the shift knob of car to
"Reverse".
⁄
• When in DVD source, "AV-OUT" cannot be set to USB.
When in USB source, "AV-OUT" cannot be set to DVD.
>
] [AV Interface]. (page 55)
"AV-IN1")

Navigation Setup

You can set Navigation parameters.
1 Display the Navigation Setup screen
Touch [ ] > [
2 Set each item
[NAV Interrupt Speaker] Selects speakers
used for voice guidance of the navigation
system. ( "Front All")
"Front L": Uses the front left side speaker for
voice guidance.
"Front R": Uses the front right side speaker for
voice guidance.
"Front All": Uses both front speakers for voice
guidance.
[NAV Voice Volume] Adjusts the volume for
voice guidance of the navigation system.
( "21")
[NAV Mute] Mutes the volume during voice
guidance of the navigation system.
( "ON")
When turned "ON", the volume level drops for
voice guidance.
[Navigation Input] Selects a navigation
system connection. (
"RGB": Allows the Kenwood's Navigation
System to connect via its interface
cable.
"AV-IN": Allows a third-party navigation system
to connect via the AV INPUT1 port.
"OFF": Must be used if no navigation system is
connected.
(The navigation display is cancelled
when the AV source is switched.)
] > [Navigation]. (page 55)
"RGB")
Next page 3
English 67