Kenwood DNX7140 Instruction Manual page 64

Setup Menu
Mileage Tracker (DNX models)
Measures the travel distance.
D
Display the Mileage Tracker screen
Touch [CD]
> [,....] >
[Information]
>
[Vehicle]
>
[Mileage Tracker]. (page 63)
II
Measure the travel distance
[] Displays up to three measurement results.
The
"~"
mark turns red during measurement.
[Start] Starts measurement of the travel
distance.
[Stop] Ends measurement of the travel
distance.
Vehicle Maintenance (DNX models)
Displays the maintenance information about the
oil change timing and so forth.
D
Display the Maintenance screen
Touch [CD]
> [,....] >
[Information]
>
[Vehicle]
>
[Maintenance]. (page 63)
II
Select the item to set
[Tire Rotation] Sets the tire rotation timing.
Notification is made when the vehicle has run
the set distance.
[Oil Change] Sets the oil change timing.
Notification is made when the vehicle has run
the set distance.
[Notification Cycle] Sets the distance the
vehicle runs before notification is made.
[Reset] Resets the distance the vehicle has run.
64 DNX7140/DNX7000EX/DDX714/DDX7034BT
[Input] Sets a distance.
D
Set a distance
[] Input a distance.
[Clear] Erases the entered digit.
If touched more than 1 second, all the input
digits are erased.
[Enter] Registers the distance.
[Cancel] Cancels the input distance.
Notification screen
When the set distance is getting close, the
maintenance notification is displayed when the
unit is turns on. Touch the check box, and then
touch the [Close] button to close the display.