Controlling Tone-Based Services; Setting Up The Hands-Free Phone - Kenwood DNX7140 Instruction Manual

Hands Free Unit Control
Controlling Tone-based Services
Uses tone base service using DTMF (Dual Tone
Multi Frequency).
D
Display the Talking screen
See <Calling by Entering a Phone Number>
(page 52).
D
Display the DTMF input screen
D
You can send tones during a call
54
DNX7140/DNX7000EX/DDX714/DDX7034BT
Setting Up the Hands-Free Phone
The Hands-Free system can be set as follows.
D
Display the Hands-Free Control screen
See <Making a call> (page 51).
D
Display the Hands Free Setup screen
D
Set the each item
[Auto Response] Sets an automatic response
time to pick-up an incoming call.
(121
"OFF")
"OFF": This function is disabled.
"0-99":
Sets the incoming call ringing duration
(in seconds)
[Phone Voice] Sets the phone call voice
I
ringing tone output position.
([2]
"Front All")
"Front
L":
Outputs the phone call voice from
the front left-hand side speaker.
"Front
R"
Outputs the phone call voice from
the front right-hand side speaker.
"Front All": Outputs the phone call voice from
both front speakers.