Changing Air Direction - Whirlpool PORTABLE AIR CONDITIONER Use & Care Manual

Time of Day
1. Press CLOCK. "00:00" will be displayed.
2. Press the up or down arrow button to set the time.
Timer Delay
To set the Timer for a 10-minute to 24-hour delay until the
air conditioner turns off (the air conditioner must be On):
1. Press TIMER OFF. Timer "OFF 00:00" indicator light will flash.
2. Press the up or down arrow button to change the delay time
from 10 minutes to 24 hours.
3. Press TIMER OFF again. Timer "OFF" indicator light and the
set time will remain on.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER ON. Timer "ON 12:00" indicator light will flash.
3. Press the up or down arrow button to change the delay time
from 10 minutes to 24 hours.
4. Press TIMER ON again. Timer "ON" indicator light and the set
time will remain on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn off air conditioner.
2. Adjust the mode to 6 th Sense
Fan or RapidCool ™ control.
3. For Cooling:
On Remote Control
Press SWING once to change vertical airflow direction. Press
again to stop airflow louver at desired airflow direction.
™ System control, Cooling, Dry,

Changing Air Direction

Adjust fan speed to Auto, High or Low.
Adjust temperature between 64ºF and 90ºF (18ºC and
32ºC).
4. For Fan Only mode, adjust fan speed to High or Low.
5. For 6 th Sense ™ System control, adjust fan speed to Auto,
High, or Low.
6. For Dry mode and 6 th Sense
temperature up or down by 4ºF (2ºC).
NOTE: In Fan Only mode, temperature cannot be set.
7. Press TIMER ON. Timer "ON 12:00" indicator light will flash.
8. Press the up or down arrow button to change delay time from
10 minutes to 24 hours.
9. Press TIMER ON again. Timer "ON" indicator light and the set
time will remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER OFF for 3 seconds to clear Timer Off
feature. Press and hold TIMER ON for 3 seconds to clear Timer
On feature. Timer indicator light will turn off.
To see or change the remaining time (in hours):
1. Press TIMER ON or TIMER OFF once after it has been
programmed.
2. While the display is showing the remaining time, you can
press the up or down arrow button to increase or decrease
the time.
NOTE: Timer On and Timer Off can be set at the same time.
Remote Control Lock
To lock the remote control, press LOCK on the remote
control.
The Lock indicator light will glow on the remote control
display.
To unlock the remote control, press LOCK on the remote
control.
On Control Panel
Press and hold FAN SPEED for 3 seconds to change vertical
airflow direction. Press and hold FAN SPEED for 3 seconds again
to stop airflow louver at desired airflow direction.
™ System control, adjust
13