Using The Remote Control - Whirlpool PORTABLE AIR CONDITIONER Use & Care Manual

NOTE: Remote control may vary in appearance.
NOTES:
Two AA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To operate the air conditioner with the remote control, aim the
remote control at the signal receptor from no more than 23 ft
(7 m) away.
The remote control indicator light will glow when remote
control is in use.
Power On or Off
Press POWER.

Using the Remote Control

Mode
1. Press MODE until you see the symbol glow for the desired
setting.
2. Choose Cooling, Dry, Fan Only or 6
Cooling—Cools the room. Press FAN to select Auto, High
or Low. Press the up or down arrow button to adjust the
temperature.
Dry—Dries the room. The air conditioner automatically
selects the temperature. Fan runs on Low speed only.
NOTE: Dry mode should not be used to cool the room.
Fan Only—Only the fan runs. Press FAN to select High or
Low.
NOTE: Auto fan speed cannot be selected in Fan Only
mode.
6 th Sense
The air conditioner automatically selects Cooling or Dry mode,
depending on room temperature and sets the temperature to
79ºF (26ºC).
The temperature set point can be adjusted down to 75ºF
(24ºC) or up to 83ºF (28ºC). Press the up or down arrow
button once to change the temperature 2ºF (1ºC) or twice to
change it 4ºF (2ºC).
th
™ System Control
™
Sense System control.
11