ELECTRICAL SYSTEM
Checking the headlight setting
13.10
A
0 0 A
Adjusting the headlight range
13.11
Changing the speedometer battery
13.12
–
Press headlight bulb
way and pull it out.
–
Insert a new headlight bulb.
Headlight (S2 / socket BA20d) (
–
Insert the rubber cap together with the lamp socket into the reflector and turn it
clockwise all the way.
Info
Ensure that the O-ring
100862-10
–
Insert the lamp socket of the parking light into the reflector.
–
Refit the headlight mask with the headlight. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
0 0 B
B
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
–
Check the headlight setting. (
–
Loosen screw
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.
101404-10
–
Tighten screw
–
Remove the headlight mask with the headlight. (
–
Remove screws
–
Pull the speedometer out of the bracket from above.
101405-10
into the lamp socket lightly, turn it counterclockwise all the
p. 102)
is seated properly.
under the first mark.
p. 83)
p. 83)
.
.
.
p. 82)
5 cm (2 in)
away from the wall.
5 m (16 ft)
p. 82)
83