SERVICE WORK ON THE CHASSIS
Removing the shock absorber
10.19
Installing the shock absorber
10.20
Removing the front fender
10.21
Installing the front fender
10.22
x
–
Raise the motorcycle with the lift stand. (
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
101344-10
x
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
101344-11
Info
The heim joint for the shock absorber at the swing arm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Make sure the spacers remain in place.
101345-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
101345-10
and lower the rear wheel with the swing arm as far as possible
, push splash protector
to the side and position the shock absorber. Mount and
.
M12
.
M12
. Remove the front fender.
p. 42)
to the side, and remove the shock
80 Nm
Loctite
®
(59 lbf ft)
80 Nm
Loctite
®
(59 lbf ft)
p. 42)
.
M6
10 Nm (7.4 lbf ft)
51
2701
2701