Cisco SPS208G User Manual page 213

Multicast
Bridge Multicast
STEP 2
STEP 3
STEP 4
STEP 5
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide
Bridge Multicast Screen
The
•
Enable Bridge Multicast Filtering – Indicates if Multicast Filtering is enabled
on the device. IGMP Snooping and MLD Snooping cannot be supported
when bridge multicast filtering is disabled. When Multicast filtering is
disabled, all multicast addresses are flooded to all ports. The possible field
values are:
-
Checked
— Enables Multicast Filtering on the device. Multicast Filtering
must be enabled to enable both IGMP Snooping and MLD Snooping.
-
Unchecked
default value.
•
Unit No. — Indicates the stacking member on which this Multicast Group
configuration is defined.
•
VLAN ID — Identifies a VLAN to be configured to a Multicast service.
•
Bridge Multicast Address — Identifies the Multicast group MAC address.
•
Enable Bridge Multicast Filtering — Enables or disables Bridge Multicast
Filtering on the device.
The interface Multicast configuration options are as follows:
•
Interface — Indicates the interface with the configuration options below.
•
Static — Indicates the interface is user-defined.
•
Dynamic — Indicates the interface is configured dynamically.
•
Forbidden — Indicates the interface is not included the Multicast group,
even if IGMP Snooping designated the interface to join a Multicast group.
•
None — The interface is not configured for Multicast service.
Select the VLAN ID.
Enter the Bridge Multicast Address for the Multicast group.
Add ports and/or LAGs to the Multicast group by selecting
Ports marked as Forbidden
Click Add to List. The configured Multicast group is displayed in the Multicast
Table at the bottom of the screen.
contains the following fields:
— Disables Multicast Filtering on the device. This is the
or None do not belong to a Multicast group.
11
Static Dynamic
or .
213