Cisco SPS208G User Manual page 143

Security Suite
ARP Inspection
STEP 1
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide
To enable ARP Inspection:
Click Security Suite > ARP Inspection. The
Figure 63 ARP Inspection Screen
ARP Inspection Screen
The
•
Enable ARP Inspection — Enables or disables ARP Inspection on the
device. The possible field values are:
-
Checked
— Enables ARP Inspection on the device.
-
Unchecked
value.
•
Enable ARP Inspection Validate — Enables or disables ARP Inspection
Validation on the device. The possible field values are:
-
Checked — Enables ARP Inspection Validation on the device.
-
Unchecked
the default value.
•
Log Buffer Interval — Defines the minimal interval between successive
Syslog messages. The possible field values are:
-
Retry Frequency
generated. The interval between successive Syslog messages is the
number of seconds entered into the (Sec) field. The range is 0-86400
seconds. The default value is 5.
contains the following fields:
— Disables ARP Inspection on the device. This is the default
— Disables ARP Inspection Validation on the device. This is
— Indicates that ARP SYSLOG messages are
ARP Inspection Screen
8
opens.
143