RHINO AGM52 Operator's Manual page 127

To change windrow form move the rear adjustable wings. The mower is equipped with two windrow-formers.
-
Adjustment of cutting height is achieved by altering the forward tilting angle of the mower. In order to tilt the
-
mower bar forward use the tractor three point linkage.
To raise up the cutting height up to 6-7 inches, is possible to equip the cutting bar with a slide plate (Cutting Height
Kit)
In general quality of mowing and power requirement depend upon:
Kind of product to be mowed;
-
Type of knives used;
-
Working height;
-
Speed of the tractor.
AGM 52-62-72-82
© 2010 Alamo Group Inc.
OPERATION
10/10 Operation Section 4-17