Programming User Codes - NAPCO GEM-RP4C Operating Manual

Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm
the system, but also to enter the User Program Mode, where you can program other User Codes. The following explains how
you will use this code to program or erase additional User Codes.
Entering the User Program Mode
1
Enter your User Code, then press
2
Answer NO (press
The display will scroll the following: "P" (Program mode); 4 digits identifying software versions; then "UP" (User Program).
The keypad sounder will beep while in the User Program Mode.
Programming / Reprogramming a User Code
1
Press , followed by the the 2 digits of the user number to be programmed ( Example: for User 4, enter 04).
A
2
, f ollowed by the new User Code (up to 6 digits).
Press
A
3
Press repeatedly until "UP" is displayed.
A
J
4
Press to save the new User Code. Note: Duplicate Codes are not allowed; therefore a duplicate Code entered in the
LCD Window will erase when
Erasing a User Code
To erase a User Code, press
• Example: Erase User 3's User Code:
Press
A03 A G0 G0 G0 G0 G0 G0
Reviewing a Programmed User Code
To review a User Code, press
22
P R O G R AM M I N G U S E R C O D E S
to enter the Function Mode.
A
) until "17" (Activate Program) is displayed, then press YES (
F
J
is pressed. Repeat Steps 1 through 4 for each User Code to be programmed.
, the 2-digit user number,
A
the 2-digit user number and
A,
followed by
A
G0
to step through and review each digit of code.
A
) .
E
until "UP" is displayed, then
("UP" will display)
J
.
J.