NAPCO GEM-RP4C Operating Manual page 7

S E T T I N G T H E AL AR M ( AR M I N G ) W H E N L E AV I N G
P
TROUBLE
CHIME
Area Arming (Optional)
In a system that has been partitioned into multiple areas, one or more areas may be armed while others remain disarmed.
Manager's Mode.
The Manager's Mode allows the user to arm / disarm other areas in a partitioned system. To arm a different area:
1. Press the numerical key representing the other area number.
2. Press followed by
G
3. Enter your code followed by
4. Press followed by
G
Global Arming
(For GEM-P9600/3200 panels only).
To arm all areas simultaneously (including the area you are in), press
To disarm all areas simultaneously, press
• The User Code must be valid in all area(s).
• If any zone is not secured, the keypad will display "P". All faulted zones in the respective area(s) must be secured or
bypassed. Note: If a system trouble is indicated, the system cannot be armed using this method.
System Trouble If you attempt to arm with the TROUBLE icon on, a 3-second tone will
sound and a "P" will display in the window. This indicates that the system has detected
a problem which may prevent it from operating properly. A number corresponding to the
trouble will then appear in the display. Refer to SYSTEM TROUBLE ERROR CODES
for descriptions of these troubles. If you cannot correct the problem immediately, press
and you will then be able to arm the system in this condition. Note: If you
C
cannot clear the trouble, have the system checked as soon as possible.
J
. The keypad will now provide status and control of that area.
J
to arm.
J
to return to the home area.
0, G
9, G
and enter your code followed by
and enter your code followed by
J
.
D
.
7