Programming User Codes; User Program Mode - NAPCO GEM-K1VPS Operating Manual

User Program Mode

Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm the
system, but also to enter the User Program Mode, where you can program other User Codes, Zone Descriptions and also set the
system Time and Date. The following explains how you will use this code to program or erase additional User Codes:
A C T I V A T E
P R O G R A M
E N T E R U S E R C O D E
1 2 3
E N T E R U S E R C O D E
E N T E R U S E R C O D E
4 5 6 7
30
P R O G R AM M I N G ( O P T I O N A L )
Enter the User Program Mode
1. Enter your User Code, then press
Y / N
2. Answer NO until "ACTIVATE PROGRAM Y/N" is displayed, then press YES. "ENTER USER
CODE" will display indicating that the system is ready for User Code programming.
Programming / Reprogramming a User Code
- -
1. Enter the digits of the user number to be programmed, followed by
For User 4, enter "04
2. Enter the new User Code. Note: User Codes may be up to 6 digits in length.
U
- -
3. Press
Code entered in the LCD Window will erase when
Repeat Steps 1 through 3 for each User Code to be programmed.
- - Erasing a User Code
1. Enter the digits of the user number to be erased followed by RR.
2. Press G0 to erase each digit of the User Code and then press
•
Example: Erase User 3's 4-digit User Code:
•
Press 03RRG0G0G0G0
R
RR
").
to save the new User Code. Duplicate Codes are not allowed; therefore a duplicate
to enter the Keypad Menu Mode.
RR
U
is pressed.
. (Example:
U
.
U
.