NAPCO GEM-RP4C Operating Manual page 28

Trouble System Trouble
Indication Condition
E-04-NN Wireless Transmitter
Supervisory Failure
E-05-NN Wireless Transmitter
Low Battery
Receiver Response
E-06-NN
Failure
E-07-00 Download Failure
E-08 Telephone Line Cut
E-09-00 System Cold Start
E-10-NN Keypad Response
Failure
28
S Y S T E M T R O U B L E E R R O R C O D E S
A problem has been detected with a wireless transmitter. Call installing company for service.
The battery in a wireless transmitter is low and should be replaced. This transmitter is on the zone
corresponding to the number NN. The replacement battery for the GEM-TRANS2 door/window
transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the Duracell DL123A 3
volt lithium. (2 required for the GEM-PIR and GEM-GB). The replacement battery for the GEM-SMK
is the Duracell MN1604 9 Volt Alkaline(2 required). The GEM-DT Dual Technology Sensor requires 4
C cell alkaline batteries.
Warning: Replace batteries only with the same type as specified above. Use of another battery may
present a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in fire.
Call installing company for service.
Call installing company for service.
The telephone line has failed. If telephone service has been temporarily interrupted, the trouble will
clear automatically when it is restored. Otherwise, call installing company for service.
Call installing company for service.
Action