Bluetooth Operation - Jensen SMPS-1000 User Manual

PAIRING (LINKING) A BLUETOOTH ENABLED CELL PHONE OR OTHER
BLUETOOTH ENABLED DEVICE to the SMPS-1000
1. With the power on, tap the SOURCE button repeatedly to select Bluetooth mode.
The Bluetooth indicator will flash blue for about 1.5 minutes. The SMPS-1000 is
ready to pair (link) with your Bluetooth device.
2. Turn on the Bluetooth feature of your cell phone and enable the search or scan
feature to find the SMPS-1000.
3. Select "SMPS-1000" from the device list when it appears on your device screen. If
required, enter the pass code "0000" to pair (link) the SMPS-1000 with your cell
phone.
4. After successfully pairing (linking) your cell phone with the SMPS-1000, the
Bluetooth indicator turns solid blue and display changes message from "PAIRING"
to "CONNECT" for few seconds then show BT mode. You can play music from
your cell phone wirelessly to the SMPS-1000.
Note: If you want to connect the SMPS-1000 to another cell phone after pairing
successfully, then you need to turn off the Bluetooth on the paired cell phone
first if it is in range before going through the above steps. Otherwise, the
SMPS-1000 will automatically reconnected to previously linked cell phone.
5. Press the VOLUME +/- button to adjust the desired volume level.
6. To turn off the SMPS-1000 Bluetooth, press the
to standby mode. Don't forget to also turn off the Bluetooth feature on your cell
phone.
Notes:
1. Refer to manual of your cell phone or other Bluetooth enabled device for
Bluetooth operation, since it may vary from model to model.
2. Pairing mode will be canceled and the LED indicator turns off if pairing is
unsuccessful within 1.5 minutes
3. If your Bluetooth enabled device does not support A2DP, it will not play the music
through the speaker, even after it's paired (linked).
4. If you are pairing (linking) your computer to the SMPS-1000 using Bluetooth, you
may need to set the SMPS-1000 as your computer's default sound device.
PLAYBACK MUSIC ON YOUR BLUETOOTH DEVICE USING THE REMOTE
CONTROL
1. Press the POWER button to turn on the unit.
2. Turn on Bluetooth of your cell phone or device which has been successful pairing
with SMPS-1000 before, press the SOURCE button to select Bluetooth mode, the

BLUETOOTH OPERATION

10
POWER button to turn the unit