Related Manuals for Jensen SMPS-610
Summary of Contents for Jensen SMPS-610
- Page 1 PORTABLE BLUETOOTH WIRELESS SPEAKER USER MANUAL SMPS-610 PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS SPEAKER AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
-
Page 2: Dear Jensen® Customer
The serial number of this product is found on its bottom cover. You should note the serial number of this unit in the space provided as a permanent record of your purchase to aid in identification in the event of theft of loss. Model Number: SMPS-610 Serial Number: ________________ COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules. -
Page 3: Protect Your Furniture
'feet' before you place the product on fine wooden furniture. PRODUCT FEATURES The SMPS-610 is a Bluetooth portable stereo speaker with the following features: • Wireless playback of music from your Bluetooth enabled device via the Bluetooth connection. -
Page 4: Location Of Controls
LOCATION OF CONTROLS 1. Bluetooth/MP3 Selector 2. Built In Microphone 3. Volume Down (-)/Skip Backward Button 4. Power / Play/Pause / Phone Button 5. Charging/Bluetooth Status Indicator 6. Volume Up (+)/Skip Forward Button 7. Built-in Speakers 8. Charging Jack (mini USB jack) 9. -
Page 5: Charging Instructions
13. Battery Compartment Door 14. Wrist Strap CHARGING INSTRUCTIONS This unit operates on a rechargeable Li-ion battery (included). Open the Battery Compartment Door. Follow the engraved diagram inside the Battery Compartment to properly install the battery. After installing the battery correctly, close the Battery Compartment Door. - Page 6 CRT TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if an unnatural color shifts or image distortion occurs. TURNING THE SMPS-610 POWER ON/OFF In power off mode, press and hold the Power Button about 2 seconds.
-
Page 7: Operating The Unit
Slide the Bluetooth/MP3 selector to Bluetooth position. After turning on the SMPS-610, a beep tone is heard and the unit will search for the last paired device. The Bluetooth Status Indicator will slowly flash blue. If the speaker finds the paired Bluetooth device, a short beep tone is heard and the Bluetooth Status Indicator will stop flashing and remain lit blue. - Page 8 Note: This feature is phone dependent. Re-linking to the cell phone If your cell phone is already paired (linked) with the SMPS-610, but became unlinked even with both Bluetooth devices turned on. You can re-link them by: Turning off the SMPS-610 and then turning it on again to re-link your cell phone.
-
Page 9: Using Headphones (Not Included)
USB cable the USB cable (included) is (included) into the mini USB jack on the not plugged into the mini SMPS-610 properly. No Charging USB jack on the SMPS-610. Wall outlet is not Plug another device into the same outlet to functioning. -
Page 10: Specifications
The SMPS-610 battery is Recharge the SMPS-610 battery. exhausted. The SMPS-610 is not linked Go through “Operating the Unit” process to with the Bluetooth enabled link the speaker. device. No Sound The SMPS-610 placement Relocate the SMPS-610 within Bluetooth is out of range. - Page 11 as a duplicate copy of a sales receipt. You must pay all shipping charges required to ship the product to SPECTRA for warranty service. If the product is repaired or replaced under warranty, the return charges will be at SPECTRA’s expense. There are no other express warranties other than those stated herein. This warranty is valid only in accordance with the conditions set forth below: 1.