HP KAYAK XM600 Troubleshooting Manual page 7

Your PC Workstation Does Not Start Correctly
Symptom
When the power button is pressed, the PC
Workstation shows no sign of activity at all:
Monitor is blank.
•
No hard disk drive or fan noise.
•
Status LED does not light up.
•
When the power button is pressed, the PC
Workstation appears to boot, but monitor remains
blank:
Hard disk drive and fan can be heard.
•
Status LED is GREEN.
•
When the power button is pressed, the PC
Workstation does not boot:
Hard disk drive and/or fan can be heard.
•
Monitor remains blank.
•
Status LED is RED.
•
Beep code is emitted.
•
When the power button is pressed, the PC
Workstation starts to boot and there is activity on
the monitor:
Boot process fails with an error message.
•
Status LED is RED.
•
When the power button is pressed, the PC
Workstation starts to boot and there is initially
some activity on the monitor, but then:
Screen becomes blank.
•
or
Image is corrupt.
•
Type of Problem
PC Workstation may not be correctly
•
connected to the power supply.
Monitor may be badly connected or not
•
switched on.
HP MaxiLife has detected a hardware
•
configuration error. A component may be
badly connected inside the PC Workstation.
Configuration error has been detected.
•
Video card may be improperly installed or
•
incorrectly configured.
Hard disk drive failure or not accessible.
•
Refer to page 9.
Refer to page 10.
Refer to page 12.
Refer to page 14.
Refer to page 16.