If You Cannot Turn Off Your Pc Workstation; If You Have Forgotten Your Password - HP KAYAK XM600 Troubleshooting Manual
Hewlett-packard personal computer user manual
Hide thumbs
Also See for KAYAK XM600:
- User manual (98 pages) ,
- Administration manual (44 pages) ,
- Hardware replacement manual (32 pages)
Table of Contents
Advertisement
Symptom...
PC Workstation does not make a
buzzing or beeping sound when
you press the power button, but
you are still unable to turn it off.
NOTE
Symptom...
You have forgotten the User password.
You have forgotten the Administrator
password.
Configuration Problems
If You Cannot Turn Off Your PC Workstation
If You Cannot Turn Off Your PC Workstation
Check that...
You have saved all data and exited all
programs.
If You Have Forgotten Your Password
Use these instructions if the passwords were set with the Setup program.
1
Switch off the PC Workstation.
2
Restart the PC Workstation. If you are prompted for a password, enter the Supervisor password.
3
When Press F2 to Enter Setup appears, press the F2 key.
4
Enter the Administrator Password to access the Setup program.
5
Go to the Security menu.
6
Go to the Set User Password field and set a new User Password. This will replace the old
password which you had forgotten.
7
Press Esc, or F3, or select Exit Menu, to save the new Password and exit Setup.
1
Switch off the PC Workstation and remove the power cord.
2
Remove the PC Workstation's cover.
3
Set switch
9
4
Replace the power cord and restart the PC Workstation.
5
When the message Passwords have been cleared appears on screen, switch off the PC
Workstation.
6
Remove the power cord and reset switch
7
Replace the PC Workstation's cover.
8
Switch on the PC Workstation and allow it to complete its startup routine.
9
After the Power-On-Self-Test has completed, press F2 when prompted to use the Setup
program.
10 Set the Administrator and new User Passwords.
11 Press Esc, or F3, or select Exit Menu, to save the new Password and exit Setup.
24
1
Save all data and exit all programs (if you can).
2
Press the power button and keep it pressed for 5 seconds.
The PC Workstation will turn off.
3
Remove the power cord.
Solution...
on the system board switch block to the
9
back to the
How...
ON
position.
OFF
position.
Advertisement
Table of Contents
Troubleshooting
