HP KAYAK XM600 Troubleshooting Manual page 14

NOTE
Case 4 — Boot Process Fails and Error Message Displayed on Screen
Case 4 — Boot Process Fails and Error Message
Displayed on Screen
When the power button is pressed, the PC Workstation starts to boot
and there is activity on the monitor, but the boot process then fails with
an error message. Status LED flashes red. A beep code may be emitted.
A configuration error has been detected.
Boot process fails with an error message.
•
Status LED is RED.
•
Before removing the cover, switch off the display and PC Workstation by pressing the
power-off button for five or six seconds. Disconnect the power cord and any accessory
cables. When checks have been completed, close the PC Workstation and reconnect
the power cord and accessory cables. Verify that the PC Workstation boots correctly.
Error Message Utility (EMU)
In the event of an error generated in POST (Power-On-Self-Test)
during the boot process, there are two beeps, then the Error Setup
Manager gives access to one or more detected errors. Each EMU error
is displayed as a 4-digit code with an associated text message on the
monitor screen.
Further details can be accessed by pressing ENTER. A detailed
description of the reason for the failure and how to solve the problem is
displayed. The following examples give the different types of error
categories.
Category #1:
If an error can be bypassed with <F1> or solved through Setup, the POST should prompt:
ERROR
0070 CPU Terminator Card Error
14
Press <Enter> to view more information about error
<F1= Continue>, <F2= Setup>