Advertisement
7
Thread leadwires and safety cable
through the downrod.
10
Install keeper pin.
13
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
16
Install remote receiver into the
mounting bracket.
8
Loosen the 2 screws on the yoke to
allow down rod to slip into yoke.
11
Tighten the 2 set screws on the
yoke, once the down rod is in place.
14
Safety cable installation
safety cable
lag screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3" lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
17
Ready for wiring.
9
Insert down rod into yoke on top of
the fan body. Align the hole in the
down rod with the hole in the yoke.
Insert the Pin through the yoke and
down rod until the point appears on
the other side.
12
Make sure the studs protruding from the
bottom of the Mounting bracket are
installed with threads all the way through
the bracket.
15
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote T ransmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly . If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter . If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
18
Fan
white
fuse
black
blue
Green
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote
marked light. Black from fan to Black from
remote marked L. White from house to white
from remote marked AC N . Black from house
to Black from remote marked AC L. Connect
all green ground wires to Ground wire from
House.
House
white
black
Advertisement
