Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3JVR52XXXD Series Fan
CUL Model NO. : 3JVR52XXD
RETAILER NAME:
RETAILER ADDRESS:
7.17 kg
15.8 lbs
Total fan weight with light
Advertisement
Related Manuals for Monte Carlo Fan Company 3JVR52 D Series
Summary of Contents for Monte Carlo Fan Company 3JVR52 D Series
- Page 1 Owner’s Guide and Installation Manual 3JVR52XXXD Series Fan CUL Model NO. : 3JVR52XXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 7.17 kg 15.8 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction. - Page 3 Before you begin installing the fan, Switch Before installing this fan make sure the Use metal outlet box suitable for fan power off at Service panel and lock outlet box is properly installed to the support and use only the screws provided service disconnecting means to prevent house structure.
- Page 4 Canopy Downrod Canopy bottom cap Keeper pin Yoke Cross pin Keeper pin Yoke cover Cross pin Downrod Partially loosen downrod set screws from Place downrod over canopy, canopy Slip downrod into motor housing yoke, aligning holes and install cross pin and yoke at top of motor assembly.
- Page 5 Step screw Grounded wire Ungrounded wires Canopy bottom Plate on motor After making the wire connections, the Partially loosen one and remove one Loosen 2 and remove 1 preassembled wires should be spread apart with the preassembled step screw from mounting screw from the plate on motor.
- Page 6 Reverse switch LIght shade Attach light shade by locating dimples in Setting the reverse switch in the down light pan with grooves on the light shade position will result in downward airflow and twist clockwise until tight. and setting the switch in the up position will result in upward airflow.
- Page 7 Wall Control Wiring, Installation and Operation Warning: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in order to avoid electrical shock. Note: Before installing the wall transmitter, place it in OFF position. (Fig.2) Make series-wound connection for the wall controller with HOT wire from house and lead wires from fan.
-
Page 8: Troubleshooting
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel. - Page 9 May.2022...