Advertisement
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3 0 6 4 9 6 4
3DYR56XX Series Fan
ETL Model NO. : 3DYR56XXXXX
RETAILER NAME:
RETAILER ADDRESS:
7.8 kgs
17.2 lbs
Total fan weight
Advertisement
Table of Contents
Related Manuals for Monte Carlo Fan Company Dylan 3DYR56 Series
Summary of Contents for Monte Carlo Fan Company Dylan 3DYR56 Series
- Page 1 Owner’s Guide and Installation Manual 3DYR56XX Series Fan ETL Model NO. : 3DYR56XXXXX Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 7.8 kgs 17.2 lbs Total fan weight...
-
Page 2: Cautions And Warnings
Note: Suitable for use in wet locations when installed in a GFCI protected branch circuit. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2015 Monte Carlo Fan Company 9/15/2015... - Page 3 Place Yoke cover on motor assembly. Warning: Cross pin and keeper pin must be installed securely, failure to install them will result in serious injury. © 2015 Monte Carlo Fan Company 9/15/2015...
- Page 4 Insert the remote receiver into mounting bracket. than the cable and no stress is placed on the lead wires. Note : If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The Outlet Box. © 2015 Monte Carlo Fan Company 9/15/2015...
- Page 5 Install blade, aligning 3 alignment posts by turning clockwise until tight. on blade with the holes in blade bracket, then install it with set screws provided. Repeat this process for remaining blades. Tighten all screws securely. © 2015 Monte Carlo Fan Company 9/15/2015...
-
Page 6: Remote Control Setting And Operation
Or you may turn power off for 15 seconds then turn power back, and then turn the fan on, Over load protection (current limit)- The device will limits the maximum current output from the receiver/drive when the fan or light load was increased abnormally. © 2015 Monte Carlo Fan Company 9/15/2015... - Page 7 4. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2015 Monte Carlo Fan Company 9/15/2013...
-
Page 8: Troubleshooting
Trouble Shooting Warning Trouble Suggested Remedy CAUTION CAUTION CAUTION © 2015 Monte Carlo Fan Company 9/15/2015... - Page 9 Sep.2015...
Need help?
Do you have a question about the Dylan 3DYR56 Series and is the answer not in the manual?
Questions and answers