Advertisement
CANADIAN MOUNTING SYSTEM INSERT
1
Feed motor lead wires through downrod/canopy
assembly and insert downrod into motor yoke.
Next, insert clevis pin through yoke and down-
rod and secure with cotter pin. (see Inset)
Tighen both yoke set screws to further secure
downrod.
4
Install mounting brackets to outlet box
in ceiling using the screws and wash-
ers provided with the outlet box.
WARNING: MOUNT ONLY TO AN OUTLET BOX
MARKED ACCEPTABLE FOR FAN SUPPORT
All set screws must be checked and retightened
2
While the fan assembly is still on the
ground thread the safety cable
through the mounting bracket.
CANADIAN SAFETY TIPS
where necessary before installation.
3
Safety Cable
Mounting
Bracket
Lift fan assembly and install the safety cable
directly to the building structure using the 3"
lag screw and plain washer provided. Before
proceeding to the the next step make sure that
the cable is properly installed and will support
the fan weight. Make sure the screw washer
and safety cable are installed using the order
pictured above.
5
Carefully lift fan assembly onto mounting brack-
et. Rotate fan so that the notch on the ball
engages the ridge in the mounting bracket. This
will allow hands-free wiring. For wiring instruc-
tions please refer to page 4 step # 8.
Advertisement
