Advertisement
7
Remove the shipping stabilizers
attached to the motor.
10
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote T ransmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly . If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter . If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
13
Fan
white
fuses
black
blue
Green
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Ground wire from
House.
16
Place blade brackets onto blades
aligning holes in blade bracket
with holes in blade. Install 3
screws and fiber washers to back
side of blade as shown. Tighten
screws securely. Repeat this
process 2 more times until all
blades are assembled.
8
Hang assembled fan from the mounting bracket
installed to ceiling in previous step. Make sure the
fan is hanging straight. Rotate fan until the tab on
the Mounting bracket engages the slot on the
Downrod Ball. This must be done to prevent the fan
body from rotating when the blades are in motion.
11
Install remote receiver into the
mounting bracket.
14
House
white
black
Make wire connections to power source using wire
nuts provided. Make sure that no filiments are out-
side of the wirenut. After making the wire connec-
tions, the wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and unground-
ed conductor on the other side of the outlet box. The
splices after being made should be turned upward and
pushed carefully up into the outlet box.
17
Install blade and blade bracket
to motor with the screws
on the
blade brackets. Tighten
securely.
9
Canadian mounting only
Safety Cable
Lag Screw
Lag Screw
Safety Cable
Washer
Lock Washer
For Canadian installation in both flush and down-
rod mode the safety cable must be installed into
the house structure beams using the 3" lag screws
provided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
12
Ready for wiring.
15
Install the canopy with the 2 hex
nut screws by using the hex-nut
driver provided(As shown).
Tighten hex-nut screws securely.
18
Loosen 2 screws and remove 1 screw
assembly
from motor plate. Save removed
pre-attached
screws for use later.
screws
Advertisement
