Page 1
4x4 HDTV Matrix U S E R M A N U A L www.gefen.com...
Page 2
Woodland Hills, CA 91367-9897 Notice Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. The 4x4 HDTV Matrix is a trademark of Gefen Inc.
The 4x4 HDTV Matrix switches four HDTV sources to any four DVI displays. The 4x4 HDTV Matrix switcher has four DVI inputs and four DVI outputs. Matrix input #1 and the DVI port of HDTV source #1 connects using a male to male DVI cable. The DVI port of HDTV source #2 connects to DVI input #2.
• DVI or HDMI to DVI cables are used to connect the inputs and outputs of the matrix • Each display's inputs can be switched with the IR remote control or through RS232 Includes: (1) 4x4 HDTV Matrix (4) DVI 6ft Male to Male Cables (1) 24VDC Power Supply...
USING THE 4X4 HDTV MATRIX Connect all the sources to the DVI inputs on the 4x4 HDTV Matrix, using the supplied cables. Connect the HDMI/DVI displays to the outputs on the 4x4 HDTV Matrix. Connect the 24VDC powersupply to the 4x4 HDTV Matrix Controlling the 4x4 HDTV Matrix using the RMT16-IR: Pressing Buttons...
RMT16-IR Installation 1. Remove battery cover from the back of the RMT16-IR remote. 2. Verify that dip switches 1 & 2 are in the down (OFF) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.
DIP SWITCH GUIDELINES Inside the 4x4 HDTV Matrix is a bank of Dip Switches. Below is a table describing their functions. By default, all switches are set to the Off position. Dip Switch # Name Description Switching Delay Adds a 3 second delay to switching...
4. Dip Switches 1 and 2 in the RMT16-IR correspond with Dip Switches 3 and 4 inside the 4x4 HDTV Matrix respectively. Switch the switches inside the 4x4 HDTV Matrix to match the same Remote Channel as the RMT16-IR. The 4x4 HDTV Matrix is now set to a new IR Code.
SPECIFICATIONS Video Amplifi er Bandwidth ................1.65 Gbps Input Video Signal ..................1.2 volts p-p Input DDC Signal ..................5 volts p-p (TTL) DVI Connector..............DVI-I 29 pin female (digital only Single Link Range ................1080p / 1920 x 1200 Remote Control Port ............RS-232 Female, Mini-Stereo Power Consumption ..................
TERMINOLOGY Short form for Display Data Channel. It is a VESA standard for communication between a monitor and a video adapter. Using DDC, a monitor can inform the video card about its properties, such as maximum resolution and color depth. The video card can then use this information to ensure that the user is presented with valid options for confi...
Gefen Inc. warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen Inc. is notifi ed within two (2) year from the date of shipment, Gefen Inc. will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifi...
Page 16
6265 Variel Avenue Woodland Hills, CA 91367 1-800-545-6900 818-884-6294 fax: 818-884-3108 www.gefen.com gsinfo@gefen.com...