Table of Contents
Advertisement
==============================================================
The first part is the mapping of 802.1P priority values 0~7 to the four priority
queues of the switch.
The second part is the port-based priority setting.
The third part is the 802.1P priority function status for each port.
3.20 show ratecontrol command will show current rate control setting for
each port.
For example,
>show ratecontrol
[Rate Control Configuration]
Packet Drop for Ingress Limit: Disable
==========================================
Port
Ingress
Egress
==========================================
1
No Limit
No Limit
2
No Limit
No Limit
3
No Limit
No Limit
4
No Limit
No Limit
5
20Mb
No Limit
6
No Limit
No Limit
7
No Limit
No Limit
8
No Limit
No Limit
9
No Limit
No Limit
10
No Limit
No Limit
11
No Limit
No Limit
12
No Limit
No Limit
13
No Limit
No Limit
14
No Limit
70Mb
15
No Limit
No Limit
Press any key to continue ...
==========================================
3.21 show rmon command will show current RMON setting (enable/disable)
of the switch.
Its syntax is ...
>show rmon
RMON Funciton: Disabled
3.22 show security command will show current Mac address security mode
for port.
Its syntax is . . .
>show security
[MAC Security Configuration]
==================================================================
Port
Static MAC Number
==================================================================
1
0
2
0
3
0
4
0
5
0
6
0
Security Control
No Security
No Security
No Security
No Security
No Security
No Security
33
Advertisement
Table of Contents
