KTI Networks KS-2601 User Manual page 20

Managed switch
Hide thumbs Also See for KS-2601:
Table of Contents

Advertisement

transparent sub-command is used to set the operation of 802.1x function to
transparent mode. In this mode, the switch will forward the 802.1x packets
only.
txtime sub-command is used to set the timeout value for the identification
request from the switch to users.
reauthcnt is met. After that, authentication fail message will be sent. The
valid value is 0~65535.
Note: This switch supports MD5, TLS and PEAP authentication types.
2.8 set guest command
This command is used to modify the user name and password for guest.
(The "guest" account is allowed to see the configuration/setting of the switch.
But the "guest" is not allowed to make any modification.)
2.9 set gvrp command
This command is used to enable/disable the GVRP function for 802.1Q
VLAN. If this function is enabled, this switch will learn the 802.1Q VLAN from
another 802.1Q network devices if it receives their packets. The learned
remote 802.1Q VLAN will be shown in the dynamic 802.1Q VLAN table.
Its syntax is . . .
>set gvrp
Syntax: set gvrp [1|0] <1:enable,0:disable>
2.10 set http command
This command is used to enable/disable the http function of the switch.
Because hacker or worm/virus (like ColdRed) often attacks http server, this
command is provided to disable http to prevent it. (If this switch is installed in
public Internet without any firewall protection, we suggest users to disable the
http interface and use Telnet or SNMP instead.)
Its syntax is . . .
>set http
Syntax
: Set http enable
Description: Enable http protocol function.
Syntax
: Set http disable
Description: Disable http protocol function.
2.11 set idle command
This command is used to set idle time for console connection. If no any key
operation in this idle time, the switch logout automatically for security.
Its syntax is . . .
Syntax: Set idle [time]
[time]: 30~3600 seconds
For example, "set idle 300" will change the idle time to 300 seconds. It is 10
minutes default. Its valid range is 30 ~ 3600 seconds.
The request will be re-tried until the
16

Advertisement

Table of Contents
loading

Table of Contents