Table of Contents
Advertisement
3.12 show igmp command will show current IGMP snooping function
enable/disable status and the IP multicast groups that learned by the switch.
For example,
>show igmp
[IGMP Configuration]
IGMP Switch
: Enabled
Total Groups
: 3
========================================================
[Group 1] IP Address
: 224.0.0.9
Member Port : 1
[Group 2] IP Address
: 224.0.0.2
Member Port : 1
[Group 3] IP Address
: 224.2.188.136
Member Port : 4,5
========================================================
3.13 show loopback command will show current loopback function setting.
(Loopback function can detect packet loopback problem happening at
connection port. If loopback is found, the connection port will be disabled.)
For example,
>show loopback
[Loopback Detection]: Disable
3.14 show mirror command will show mirror function configuration of the
switch. For example,
>show mirror
[Mirror Configuration]
Mirror Switch:Disabled
Capture port :1
Ingress DIV=3
Mode=SA MAC=00-00-01-11-22-33
Port List: 2
Egress DIV=1
Mode=ALL MAC=00-00-00-00-00-00
Port List:
This setting will mirror those packets that with source Mac address 00-00-01-
11-22-33 ingress to Port 2 to Port 1 for every three matched packets.
3.15 show net command will show current IP address configuration of the
switch. If DHCP is enabled, this command will show the IP configuration got
from DHCP server. For example,
>show net
[net] Network Configuration:
DHCP
: DISABLE
IP Address: 192.168.1.5
Netmask : 255.255.255.0
Gateway : 192.168.1.120
3.16 show port command will show status and configuration of each
connection port.
For example,
>show port
[Port Configuration]
30
Advertisement
Table of Contents
