HP StorageWorks e1200-160 User Manual page 72

Visual Manager User Interface
Viewing and Changing SCSI Map Information
To view or change current SCSI map information:
1. In the Mapping Menu screen, select the desired SCSI bus.
2. Select Edit/View in the Map section of the screen.
3. Enter the new settings and then click the appropriate action button.
Figure 25: SCSI Map Dialog box
Note:
Target ID must be enabled from the SCSI Bus Configuration Menu. A Target ID should
only be added if there is a SCSI initiator that needs to address Fibre Channel devices.
Each Target ID can be used to store up to 32 Fibre Channel devices.
72
The SCSI Map dialog box is displayed. Current map information is shown at
the top of the dialog box.
Figure 25 is an example of the SCSI Map dialog box.
To map Fibre Channel devices to any SCSI initiator on the selected bus, a
Network Storage Router e1200-160