HP StorageWorks e1200-160 User Manual page 61

Note:
Note:
use Fibre Channel devices. This type of configuration is known as a Target Mode
configuration.
Note:
devices complete their individual power-ups.
Network Storage Router e1200-160
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change
and verify the desired setting. HP recommends backing up the router
configuration to an external file before making changes to this setting.
Target IDs must be setup before mapping devices on the SCSI bus.
Do not enable Target IDs unless there is a SCSI initiator on the bus that wants to
Discovery toggles between Enabled and Disabled.
Discovery Delay is the wait time after a power-up or reboot before
discovering SCSI devices.
HP recommends setting the value to at least 30 seconds to ensure all SCSI
Bus Reset on Boot toggles between Enabled and Disabled.
When enabled, the router will automatically reset SCSI buses during a power
up or reboot of the router.
Internal Termination toggles between Enabled and Disabled.
Caution: If this configuration setting is incorrectly set, processing difficulties
may occur. Before changing this setting, evaluate the need for the change
and verify the desired setting. HP recommends backing up the router
configuration to an external file before making changes to this setting.
When enabled, internal termination of the selected SCSI bus is allowed.
When disabled, the SCSI Bus, not the router handles SCSI termination.
Buffered Tape Writes (default: Enabled) toggles between Enabled and
Disabled.
Visual Manager User Interface
61