Table of Contents
Advertisement
Audio controls and indicators
Audio configuration/save button and LED — The Audio button and LED
3
enable the user to view and/or change the current audio level setting for each
input. See Audio gain and attenuation in this chapter.
Down (
4
level for a selected input. The LED flashes each time the button is pressed to
indicated a 1 dB decrease in the audio level. See Audio gain and attenuation in
this chapter.
On the SW2 RGBHV A, this button and LED are secondary functions of the
Input 1 button and LED. On the SW6 RGBHV A, this button and LED are
secondary functions of the Input 5 button and LED.
Up (
) button and LED — The
5
for a selected input. The LED flashes each time the button is pressed to
indicated a 1 dB increase in the audio level. See Audio gain and attenuation in
this chapter.
On the SW2 RGBHV A, this button and LED are secondary functions of the
Input 2 button and LED. On the SW6 RGBHV A, this button and LED are
secondary functions of the Input 6 button and LED.
–dB/+dB LEDs — The –dB and +dB LEDs indicate the polarity of the audio
6
level setting. See Audio gain and attenuation in this chapter.
Audio level indicators (SW4 RGBHV A and SW6 RGBHV A only) — The
7
Input 1 through Input 4 LEDs indicate a range of 6 dB when lit (Input 1 LED
off = 0 dB to 5 dB, Input 1 LED lit = 6 dB to 11 dB, Input 2 LED lit = 12 dB to
17 dB, and so on). See Audio gain and attenuation in this chapter.
Autoswitch mode control and indicator
When autoswitching is enabled, the switcher continuously monitors all inputs and
automatically switches to the highest-numbered input with video sync pulses
present. If video is absent from all inputs, no input is selected.
Auto/Manual switch — The rear panel Auto/Manual toggle switch
8
(figure 3-3) selects autoswitching mode or manual switch mode.
SW2 Models
H/HV
Figure 3-3 — Rear panel Auto/Manual switch
Auto Switch Active LED — When lit, the front panel Auto Switch Active LED
9
indicates that the switcher is in autoswitch mode. When unlit, the switch is in
normal (manual) mode.
) button and LED — The
button is used to increase the audio level
SW4 and SW6
Models
REMOTE
V
AUTO
REMOTE
AUTO
MANUAL
MANUAL
8
8
SW RGB and YUV A Switchers • Operation
button is used to decrease the audio
3-3
Advertisement
Table of Contents
