All Models - Extron electronics SW2 RGBHV User Manual

Introduction, cont'd

All models

Bandwidth — Bandwidth is 350 MHz (-3 dB). This high bandwidth allows the
Input signal sensing — The switcher continuously monitors all inputs to sense
Autoswitching mode — When autoswitching is enabled, the switcher continuously
Operational flexibility — The operator can select the input and set the audio gain
Rack mount — Rack mountable in any conventional 19" wide rack with the
Power supply — Includes an internal 100 VAC to 240 VAC, 50/60 Hz, 20 watts,
1-4 SW RGB and YUV A Switchers • Introduction
switchers to switch all of the high-resolution video signals with no loss of
signal quality.
when the input signal is active or inactive. The switcher reports changes in
the status of each input (active to inactive or inactive to active) on the RS-232
port.
monitors all inputs and automatically switches to the highest-numbered
input with video sync pulses present. If video is absent from all inputs, no
input is selected.
and attenuation for each input using the front panel buttons or via the
switcher's Remote port RS-232 link. The RS-232 link allows remote control
via a PC or control system. The operator can select inputs via the switcher's
contact closure link on the Remote port. The operator can also remotely
control the switchers using a contact closure keypad connected to the Remote
port or an Extron IR 102 Universal remote control kit (part #70-224-01)
connected to the Remote port.
supplied rack ears. The two SW2 models require an optional 1U Universal
Rack Mount Kit (part #60-190-01) for rack mounting.
auto-switchable power supply, which provides worldwide power
compatibility.