Under-Furniture Mounting The Switcher; Sw2 Models; Sw4 And Sw6 Models - Extron electronics SW2 RGBHV User Manual

Installation, cont'd
Under furniture mounting the switcher
The SW2 switcher models can be mounted under a table or other horizontal surface
with an optional Extron under-desk mounting kit (part #70-077-01). The SW4 and
SW6 switcher models can be mounted under a table or other horizontal surface
with an optional Extron 1U under-desk mounting kit (part #70-222-01).

SW2 models

1.
2.
Figure 2-3 — Under-desk mounting
3.
4.
5.
6.

SW4 and SW6 models

1.
2.
2-4 SW RGB and YUV A Switchers • Installation
Secure the optional under-desk mounting brackets to the switcher with the six
machine screws provided in the mounting kit (figure 2-3).
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the desk.
AU
TO
SW
IC H
AC UT
IV E
1
2
RG S W
BH
V & 2 R
AU G B
DI
O H V
SW IT CH
ER
Under Desk Kit
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
Slide the switcher slightly forward or back, then tighten all four screws to
fasten it in place.
Secure the optional table/wall mounting brackets to the switcher with the
eight machine screws provided in the mounting kit (figure 2-2).
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the underside of the
desk.