Extron electronics HDMI 201 User Manual page 15

PMK 350 mounting
Mount the receiver to a PMK 350 bracket as follows:
1. Remove the front and rear plates from the PMK 350 (figure 8), using an Extron
Tweeker or a #2 Phillips screwdriver . Retain the screws to reattach the plates.
Rear Plate
Extron
U-bolt
PMK 350
Multi-product Pole
Mount Kit
Extron
Power Supply
Figure 8. PMK 350 Projector Mounting a Receiver
2.
If necessary, remove the feet from the bottom of the receiver.
3.
Secure the receiver to one side of the mounting tray, using two of the supplied
4-40 x 3/16-inch screws in opposite (diagonal) corners.
4.
If power supply is connected to the receiver, use the two included tie wraps to strap
the power supply to the bracket.
5.
Place the PMK 350 around the projector ceiling mounting pole (figure 8).
6.
Assemble the U-bolt and the following parts in the following order (figure 9):
a. Pass the legs of the U-bolt through the slotted holes on the mount plate flange.
b.
Place the legs around the projector pole.
c.
Pass the legs through the holes in the contour base.
NOTE: The pole fits snugly into the depression in the center of the contoured
base.
d. Pass the legs through the holes in the L-shaped bracket.
NOTE: The supplied U-bolt fits a typical (1.5-inch to 2.0-inch diameter) ceiling
pole.
Mount Plate
Flange
U-bolt
Slotted Hole
in PMK Tray
Ceiling
Pole
Figure 9. Hanging the Tray on the Pole
Extron
Quarter-rack
Sized Product
Front Plate
Cover Sheet
Contoured
Base
L-shaped
Bracket
HDMI 201 • Installation and Operation
Contoured
Base
L-shaped
Bracket
L-shaped
Bracket Screws
11