Power Seat (Optional); Operation Using Power Seat Switch And Throttle Control Lever; Operation With Power Seat Switch Only - Pride HURRICANE Owner's Manual

V I . C O M F O R T A D J U S T M E N T S

POWER SEAT (OPTIONAL)

Your PMV may be equipped with a power seat option. A power seat switch will be located on the tiller console.
See figure 5. The power seat will be equipped with one of two operating systems. Refer to figures 14 and 15
to determine which system your PMV uses and follow the appropriate instructions for safe operation.
WARNING! The power seat is intended for operation only while your PMV is stationary
and on a level surface. Its purpose is to aid you in reaching objects. Drive your PMV only
with the power seat in the lowest position. Driving the PMV with power seat elevated
could result in personal injury, equipment, and/or property damage.
Strict adherence to the following safety rules is vital to your safety:
Operate the power seat only while completely stationary on level ground.
Do not press the throttle control lever and the power seat switch at the same time.
Do not operate your PMV with the power seat elevated. Operate the PMV only with
the power seat fully retracted (in the lowest position).
Never place your PMV in freewheel mode with the power seat elevated.
Use extreme caution when reaching for objects with your power seat elevated. Do
not overextend or attempt to pick up objects that might affect your balance.
Do not attempt to raise or lower the seat while in motion.
Before operating the power seat, ensure your PMV is level and stationary and the speed adjustment dial is
set to the slowest setting.
System 1 - Operation using power seat switch
and throttle control lever:
1. Release the throttle control lever.
2. Toggle the power seat switch located on the til-
ler console to the "on" position. See figure 14.
3. To raise the power seat, operate your throttle
control lever in the forward direction.
4. Release the throttle control lever when you
have attained your desired height.
5. To lower the power seat, operate your throttle
control lever in the reverse direction.
6. Ensure your seat is in the lowest position and
that you have fully released the throttle control
lever.
7. Toggle "off" the power seat switch before you
attempt to drive your PMV again.
THROTTLE CONTROL LEVER
Figure 14. Power Seat Switch (With Vertical Line And Cir-
cle) Used In Conjuction With Throttle Control Lever to
Activate The Power Seat Actuator (Switch Shown In The
"Off" Position)
30
System 2 - Operation with power seat switch only:
1. To raise the power seat, press and hold the upper
part of the switch. Release the switch when you
have attained your desired height or upon reach-
ing the highest position. See figure 15.
2. To lower the power seat, press and hold the
lower part of the switch. Release the switch
when you have attained your desired height or
upon reaching the lowest position.
NOTE: The PMV must be stopped in order for the
power seat to be operated. If the power seat switch is
pressed while the PMV is in motion, the PMV will slow
and come to a stop. The PMV may also produce a fault
code indicated by the Status LED on the console. If a
fault code occurs, you will need to turn the PMV's
power off then back on again before proceeding.
Figure 15. Power Seat Switch (With No Markings)-Activates
The Power Seat Actuator
www.pridemobility.com Hurricane