Positioning Belt (Optional) - Pride PATHRIDER 140 XL Owner's Manual

V I . C O M F O R T A D J U S T M E N T S

POSITIONING BELT (OPTIONAL)

Your scooter seat may be equipped with an auto-
type positioning belt that can be adjusted for
operator comfort. The positioning belt is
designed to help support the operator so that he or
she does not slide down or forward in the seat.
The positioning belt is not designed for use as a
restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can
see the bottom of the seat base. See figure 17.
3. Use a wrench to remove the two back bolts on
the outermost part of the rear seat.
4. Insert the bolt through the appropriate ends of
the positioning belt and then reinstall the
bolts and belt back into the seat bottom.
5. Tighten the bolts.
To adjust the positioning belt for operator
comfort:
1. Insert the metal tab on the right side of the
belt into the plastic housing on the opposite
strap until you hear a "click." See figure 19.
2. Pull the strap on the right side of the belt until
it is secure, but not so tight as to cause dis-
comfort.
MANDATORY!
positioning
secured to the scooter and is
adjusted for operator comfort
before each use.
MANDATORY! Inspect the posi-
tioning belt for loose or damaged
parts before each use of the
scooter. If you discover a prob-
lem, contact
Pride Provider for maintenance
and repair.
Pathrider 140 XL
Make sure the
belt is properly
your authorised
www.pridemobility.com
Figure 19. Positioning Belt
35