Care And Maintenance; Tire Pressure; Exterior Surfaces; Cleaning And Disinfection - Pride HURRICANE Owner's Manual

I X . C A R E A N D M A I N T E N A N C E
Your PMV requires a minimal amount of care and maintenance. If you do not feel confident in your ability
to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized
Pride Provider. The following areas require periodic inspection and/or care and maintenance.

TIRE PRESSURE

If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is critically important that the psi/bar/kPa air pressure rating be maintained
in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure
may result in loss of control and overinflated tires may burst. Failure to maintain the psi/
bar/kPa air pressure rating indicated on pneumatic tires at all times may result in tire
and/or wheel failure.
Regularly inspect your PMV's tires for signs of wear.

EXTERIOR SURFACES

Bumpers, tires, trim, and the tiller boot can benefit from an occasional application of a rubber or vinyl
conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the PMV's vinyl seat or tire tread,
as they will become dangerously slippery.

CLEANING AND DISINFECTION

Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your PMV.
Avoid using products that may scratch the surface of your PMV.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or
cleaning agent before applying it to your product. Failure to comply may result in skin
irritation or premature deterioration of upholstery and/or PMV finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and uncorroded.
The batteries must sit flat in the battery wells.
The battery terminals should face the rear of the PMV.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
These items are all prelubricated, sealed, and require no subsequent lubrication.
MOTOR BRUSHES
The motor brushes are housed inside of the motor transaxle/assembly. They should be inspected periodi-
cally for wear by your authorized Pride Provider.
CONSOLE, CHARGER, AND REAR ELECTRONICS
Keep these areas free of moisture.
Allow these areas to dry thoroughly if they have been exposed to moisture before charging the batteries
and operating your PMV again.
36
www.pridemobility.com Hurricane