Seat Adjustments - Pride Libre SCOOTER SERIES Owner's Manual

I I I . Y O U R
Tiller Lock Knob
The tiller lock knob allows the tiller to be locked in the
straight ahead position. Locking the tiller is helpful when
transporting the Travel Scooter because it will stabilise the
front wheel, keeping the Travel Scooter from moving from
side to side.
WARNING! Before getting onto your
Travel Scooter, always check that the
tiller lock knob is in the unlocked
position. See figure 6A. Attempting to
ride your Travel Scooter with the tiller
lock knob in the locked position can
result in personal injury.
From the unlocked position (see figure 6), lock the front
wheel by pushing the tiller lock knob in and turning it clock-
wise 90°. See figure 6A.

SEAT ADJUSTMENTS

To adjust the height of the seat:
1. Remove the seat by lifting it straight up and off of the
Travel Scooter.
2. Use the attached ring to pull and remove the detent pin
from the lower seat post. See figure 7.
3. Raise or lower the upper seat post to the desired
seat height.
4. While holding the upper seat post at that height, align
the adjustment holes of the upper and lower seat posts.
5. Fully insert the detent pin.
6. Reinstall the seat.
To adjust the width of the armrests:
1. Loosen the armrest adjustment knobs located at the
rear of the seat.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs as required.
NOTE: The armrests can also pivot upwards to aid in
getting onto and off of the Travel Scooter.
20
T R A V E L
Figure 6. Tiller Lock Knob (Unlocked)
Figure 6A. Tiller Lock Knob (Locked)
Figure 7. Seat Height Adjustment
www.pridemobility.com
S C O O T E R
UNLOCKED POSITION
LOCKED POSITION
UPPER SEAT POST
LOWER SEAT POST
DETENT PIN
Pride Scooter Series