Seatback Adjustment; Armrest Angle Adjustment; Seat Height Adjustment - Pride Ultimate 3 CF3001 Owner's Manual

V I I . C O M F O R T A D J U S T M E N T S

SEATBACK ADJUSTMENT

To adjust your scooter's reclining seat, perform these
steps. See figure 11.
1. While pulling up on the seatback adjustment lever,
lean forward or rearward to adjust the seatback.
2. Release the seatback adjustment lever once the
seat is in a comfortable riding position.

ARMREST ANGLE ADJUSTMENT

The armrests of your scooter can be adjusted upward
or downward. See figure 12. By turning the
adjustment dial, the armrest will either raise or lower.
NOTE: The armrests also pivot upward to make
getting on and off of your scooter easier.

SEAT HEIGHT ADJUSTMENT

You can change the seat height to one of three posi-
tions in 2.5 cm increments. See figure 13.
Changing the seat height:
1. Turn the scooter off and place the manual free-
wheel lever in drive mode.
2. Lift the seat up and out of the seat post.
3. Loosen and remove the seat height adjustment
bolt, bolt-nut, and washers.
4. Slide the upper seat post up or down in the lower
seat post.
5. Align the adjustment holes of the upper seat post
and the lower seat post.
6. Reinstall the seat height adjustment bolt, bolt-
nut, and washers, then tighten.
7. Reinstall the shroud.
8. Reinstall and lock the seat into place.
Ultimate
SEATBACK ADJUSTMENT
LEVER
Figure 11. Seatback Adjustment
ADJUSTMENT DIAL
Figure 12. Armrest Angle Adjustment
WASHER
BOLT-NUT
Figure 13. Seat Height Adjustment
www.pridemobility.com
UPPER SEAT POST
WASHER
SEAT HEIGHT
ADJUSTMENT BOLT
LOWER SEAT POST
29