Replacing The Pump And Generator Drive Belts; Checking And Adjusting The Throttle Control - Husqvarna PT 26D Operator's Manual

Replacing the pump and generator drive belts

1. Release the belt tension for the pump and
generator drive belts completely and pry off the
belts. If necessary, slacken off the generator's
lower mounting screw slightly if the generator is
securely fastened.
2. Install a new belt.
3. Adjust the pump and generator belts as above.

Checking and adjusting the throttle control

Do not adjust the stop screws on the regulator
housing, the engine's warranty may become invalid.
If doubts arise, contact a Husqvarna service workshop.
Maintenance
81