What To Do If - Progress PBD3500X User Manual

Steam oven
Hide thumbs Also See for PBD3500X:
Table of Contents

Advertisement

Available languages

Available languages

Installing the door and the glass panel

WHAT TO DO IF...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not oper-
ate.
There is water inside the oven.
The indicator "Tank Full"
off.
The indicator "Tank Empty"
is on.
The steam cooking does not
work.
The steam cooking does not
work.
It takes more than three mi-
nutes to empty the water tank
or the water leaks from the
steam inlet opening.
The display shows 12.00.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
There is too much water in the
tank.
There is no enough water in
is
the tank.
There is no water in the tank.
There is no water in the tank.
Lime obstructs the hole.
There are lime deposits in the
oven.
There was a power cut.
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the in-
ner side of the door. Make sure that after
the installation the surface of the glass pan-
el frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the internal glass
panel in the seats correctly. Refer to the il-
lustration.
Activate the appliance.
Set the clock.
Make sure that the settings are
correct.
Do a check of the fuse. If the
fuse is released more than one
time, contact a qualified electri-
cian.
Replace the oven lamp.
Deactivate the oven and wipe
the water with a cloth or
sponge.
Fill the tank with water until the
indicator comes on. If water
starts to come out inside the
oven, and the indicator is still
off, contact a qualified service
engineer.
Fill the tank. If the indicator is
still on, contact a qualified serv-
ice engineer.
Fill the water tank.
Check the steam inlet opening.
Remove the lime.
Clean the water tank. Refer to
"Cleaning the water tank".
Set the clock.
progress 25
Remedy

Advertisement

Chapters

Table of Contents
loading

Table of Contents